J-SCAN - the ultimate JTAG debugger

J-SCAN

Affordable and easy-to-use, J-SCAN has become a top choice of hundreds of hardware design engineers and test technicians for JTAG boundary scan test and flash programming. (click on image to enlarge)

Test JTAG Devices

How many times have you wished you could get a scope probe to an unreachable pin, wire a jumper so you can force a pin to a known state, or connect an LED to a pin to see what it is doing?

J-SCAN lets you view and control JTAG pins in real time without having to touch your board! With a simple click of your mouse, you can set pins HIGH or LOW and observe the results right from your PC screen.

J-SCAN works independently of any logic inside the JTAG device, you do not need to have any code or firmware installed. 

Program JTAG Flash Memories

It could not be any easier to program FLASH devices on your board.

Simply indicate which JTAG pins are connected to your FLASH device, select your data file and click PROGRAM. That’s all there is to it! No netlists, no test vectors, no test fixtures or test executives required!

See J-SCAN flash programming in action with the latest of our technical training videos: “Introduction to JTAG Flash Programming”

Easy to Use and Affordable!

J-SCAN is so simple to use you’ll be up and running in minutes even if you have no previous boundary scan test experience.

View, monitor and control inaccessible solder balls under BGA devices.
Seeing is Believing!

WHAT YOU GET ...

$1895.00  

Already have a usbDemon?

You can purchase the kit without a usbDemon. You will then be issued a license code to program into your usbDemon to allow it to work with J-SCAN. AVAILABLE FOR WINDOWS BASED PCs ONLY at this time.

$1145.00